网站转让 → 您的公司名称

谈谈你知道怎样解决塑料检查井漏水的问题么

Do you know how to solve the problem of water leakage in plastic inspection wells?

一、胶圈没有配好，没能做到正真的闭水。

1. The apron is not properly matched, and it can not really shut down the water.

二、选用的产品不稳定，管道、塑料检查井都是塑料制品，塑料有收缩率，可能每批的产品都有一定的误差，现场施工时可能出现开始安装能闭水，之后施工就产生漏水现象。避免这种情况的发生首先要选择优质的产品，降低产品产生误差率的概率。其次及时的发现问题，更换合适的橡胶圈。

Second, the selected products are unstable, pipelines, plastic inspection wells are plastic products, plastic shrinkage, each batch of products may have a certain error, the site construction may start to install the water can be closed, then the construction will produce leakage phenomenon. To avoid such a situation, we must first select quality products and reduce the probability of error rate. Secondly, find out the problems in time and replace the suitable rubber rings.

三、施工时，橡胶圈固定不到位，甚至出现橡胶圈翻转的现象。所以说规范的施工是保证工程质量的前提。

Three. During construction, the rubber ring is not fixed enough, or even the rubber ring is turned over. Therefore, the standard construction is the premise to ensure the quality of the project.

四、产品在运输过程中产生变形。变形不太厉害的时候，安装的时候能稍微弥补下，但是严重的话就很难做到不漏水了，可以适当的调换产品，以保证工程的质量。

Four, product deformation during transportation. When the deformation is not too severe, the installation can make up for it slightly, but if it is serious, it is very difficult not to leak. The product can be properly replaced to ensure the quality of the project.

漏水是塑料检查井在施工时遇到最多，也是最头疼的问题.江苏正林环保科技有限公司在塑料检查井的销售中积累了丰富的经验，橡胶圈的配置全面，在所做工程中能够做到很好的闭水效果，得到广大用户的一致好评。

Leakage is the most common and headache problem encountered in the construction of plastic inspection wells. Jiangsu Zhenglin Environmental Protection Technology Co., Ltd. has accumulated rich experience in the sales of plastic inspection wells. Rubber rings are fully equipped, which can achieve good water shut-off effect in the project, and has been praised by the majority of users.